Filter
Top Products
Display assembly
Description Spare part number
12.1-in, WXGA AntiGlare LED display assembly for use only with computer models equipped with a
webcam (includes display panel cable, WLAN antenna transceivers and cables, and WWAN
antenna transceivers and cables.
598794-001
12.1-in, WXGA AntiGlare LED display assembly for use only with computer models not equipped
with a webcam (includes display panel cable, WLAN antenna transceivers and cables, and WWAN
antenna transceivers and cables.
598795-001
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
Battery on page 44).
5. Remove the memory module compartment cover (see
Expansion memory module on page 48).
6. Remove the wireless module compartment cover (see
WLAN module on page 53).
7. Disconnect the wireless antenna cables from the WLAN module (see
WLAN module
on page 53) and the WWAN module (see WWAN module on page 57).
8. Remove the switch cover and keyboard (see
Switch cover and keyboard on page 65).
Remove the display assembly:
1. Close the computer and turn it upside down, with the rear panel toward you.
2. Remove the two rubber screw covers (1) and the two Torx T8M2.0×6.0 screws (2) from the
bottom of the base enclosure.
3. Remove the two Torx T8M2.0×6.0 screws (3) from the rear panel.
4. Turn the computer right-side up, with the front toward you.
72 Chapter 4 Removal and replacement procedures