10
Preparing for the remote control
Please insert the batteries into the remote control before using it. If the remote
control starts to malfunction, try to replace the batteries. If you will not use the
remote control for long period, remove the batteries from the remote control and
store them in a safe place.
1.
Holding the hook part of the battery
cover, remove it.
2.
Align and insert the two AA batteries
(
HITACHI MAXELL, Part No.LR6 or R6P)
according to their plus and minus terminals
as indicated in the remote control.
3.
Replace the battery cover in the direction of the arrow and snap it back into
place.
WARNING ŹAlways handle the batteries with care and use them only as
directed. Improper use may result in battery explosion, cracking or leakage,
ZKLFKFRXOGUHVXOWLQ¿UHLQMXU\DQGRUSROOXWLRQRIWKHVXUURXQGLQJHQYLURQPHQW
%HVXUHWRXVHRQO\WKHEDWWHULHVVSHFL¿HG'RQRWXVHEDWWHULHVRIGLIIHUHQW
types at the same time. Do not mix a new battery with used one.
Make sure the plus and minus terminals are correctly aligned when loading a battery.
.HHSDEDWWHU\DZD\IURPFKLOGUHQDQGSHWV
'RQRWUHFKDUJHVKRUWFLUFXLWVROGHURUGLVDVVHPEOHDEDWWHU\
'RQRWSODFHDEDWWHU\LQD¿UHRUZDWHU.HHSEDWWHULHVLQDGDUNFRRODQGGU\SODFH
If you observe battery leakage, wipe out the leakage and then replace a battery.
If the leakage adheres to your body or clothes, rinse well with water immediately.
2EH\WKHORFDOODZVRQGLVSRVLQJWKHEDWWHU\
21
3
7U\FKDQJLQJWKHEDWWHULHVZKHQWKHUHPRWH
control malfunctions.
7KLVUHPRWHFRQWUROZRUNVZLWKWKHUHPRWH
sensors on the projector using infrared light
(Class 1 LED). The active sensor senses
the remote control signal assigned within 60
degrees to right and left, and within 3 meters.
)RUGHWDLOVVHHWKH2SHUDWLQJ*XLGHLQWKH&'
3UHYHQWWKHUHPRWHVHQVRUVIURPEHLQJKLWE\
a strong ray. It may cause malfunction of the
projector and remote control.
NOTE
Remote sensors
3m
DSSUR[
30°
30°