Hitachi ED-AW110N Projector User Manual


 
21
ENGLISH
Replacing the internal clock battery
Consumption of the battery makes the clock not to work correctly. When the clock
is wrong or it has stopped, please replace the battery according to the following
procedures.
1.
Turn the projector off, and unplug the power cord. Allow the
SURMHFWRUWRFRROVXI¿FLHQWO\
2.
After making sure that the projector has cooled adequately,
slowly turn over the projector, so that the bottom is facing.
3.
Turn the battery cover fully in the direction indicated “OPEN
using a coin or the like, and pick the cover up to
remove it.
4.
3U\XSWKHEDWWHU\XVLQJDÀDWKHDGVFUHZGULYHURUWKHOLNH
WRWDNHLWRXW:KLOHSU\LQJLWXSSXWD¿QJHUOLJKWO\RQWKH
battery since it may pop out of the holder.
5.
Replace the battery with a newHITACHI MAXELL, Part
No.CR2032 or CR2032H.
Slide the battery in under the plastic claw, and push it
into the holder until it clicks.
6.
Replace the battery cover in place, then turn it in the
direction indicated “CLOSE´XVLQJVXFKDVFRLQVWR¿[
WARNING ŹAlways handle the batteries with care and use them only as
GLUHFWHG%DWWHU\PD\H[SORGHLIPLVWUHDWHG'RQRWUHFKDUJHGLVDVVHPEOHRU
GLVSRVHRILQ¿UH
And also improper use may result in cracking or leakage, which could result in
¿UHLQMXU\DQGRUSROOXWLRQRIWKHVXUURXQGLQJHQYLURQPHQW
%HVXUHWRXVHRQO\WKHEDWWHULHVVSHFL¿HG
Make sure the plus and minus terminals are correctly aligned when loading a battery.
.HHSDEDWWHU\DZD\IURPFKLOGUHQDQGSHWV,IVZDOORZHGFRQVXOWDSK\VLFLDQ
immediately for emergency treatment.
Do not short circuit or solder a battery.
'RQRWDOORZDEDWWHU\LQD¿UHRUZDWHU.HHSEDWWHULHVLQDGDUNFRRODQGGU\SODFH
If you observe battery leakage, wipe out the leakage and then replace a battery. If the
leakage adheres to your body or clothes, rinse well with water immediately.
2EH\WKHORFDOODZVRQGLVSRVLQJDEDWWHU\
OPEN
CLOSE
OPEN
CLOSE
OPEN
CLOSE
OPEN
CLOSE
%DWWHU\&RYHU