Filter
Top Products
www.hi-ti.com
19
[Device Option]
You can modify the settings of the card printer in this page.
A.
Ribbon Type: Select the ribbon type you want to use. 1. YMCKO ribbon,2. Resin K
ribbon or 3. YMCO ribbon.
B.
Card Type: Select the card type you want to use. You may choose “Blank Card”,
“6-pin Smart Chip Card”, “8-pin Smart Chip Card”, “Magnetic Stripe Card”,
“Chip/Magnetic Card”, and “Adhesive Card”. (Default setting: “Blank Card”)
C.
Quality Mode: Quality Mode is the default setting. If you cancel this option, the
printing speed will increase, but the quality will decrease.
D.
Printing Direction: You can select “Portrait” or “Landscape”. (Default setting:
“Landscape”)
Lock: If you are using a 3
rd
party software application other than Card Desiree CS
and the default printer of your computer is not CS-300, then please enable “Lock”
to fix the printing direction.
E.
Copies: Set the number of copies to print. (Default setting: 1)
F.
Front/ back side setting: Setup which side you want to print.
G.
Printing Parameters: Select the printing parameters. When you change the
Ribbon type, it will automatically return to the default setting. If □
□□
□Using YMC is
unmarked, only the Resin K and O portion of the YMCKO ribbon will be applied
during the printing process.
H.
K only on Back: This option is available only for YMCKO ribbons. When it is
marked, the front side of the card will be printed by YMC of YMCKO; meanwhile,
the back side will be printed by K of YMCKO. Then the user can print out one
double-side card by one set of YMCKO (YMC for the front side; K for the back side).
A
B
C
D
E
F
G
H