Filter
Top Products
8 - 3
Resetting the Standard Product Default Settings:
All Application Work Groups
The following bar code defaults all of the work groups to the factory settings.
The Menu Commands starting on page 10-6 list the standard product default
settings for each of the commands (indicated by an asterisk (*) on the program-
ming pages).
Temporary Visual Xpress Configuration
For quick download communication configuration, scan the Visual Xpress bar
code to temporarily configure the imager for Visual Xpress settings. Refer to
Visual Xpress on page 9-1 for additional information about Visual Xpress.
Note: Connect the imager using RS-232 cables. Scan the bar code below and
the unit will communicate in RS-232 mode, allowing it to work with Visual
Xpress. The imager reverts to the original or reprogrammed interface
when the power is cycled.
Note: If you download new software into a unit, the user-programmed
parameters are retained. If you need to discard user-programmed
settings, scan the Standard Product Default Settings bar code (see
Resetting the Standard Product Default Settings: Current Application
Work Group on page 8-2).
Standard Product Default Settings:
All Application Groups
Visual Xpress