Honeywell 3820 Barcode Reader User Manual


 
10 - 5
The Menu Commands starting on page 10-6 list the factory default settings for
each of the commands (indicated by an asterisk (*) on the programming pages).
Note: Scanning this bar code also causes both the image scanner and the base
to perform a reset and become unlinked. Refer to "Linking Image
Scanner to Base" on page 1-5 for additional information.
Note: If your image scanner is in multiple image scanner mode and you scan
either the current or all application group default bar code, you will hear
up to 30 seconds of beeping while all image scanners are re-linked from
the base and the settings are defaulted to * settings. The default interface
is keyboard wedge and the default image scanner mode is single image
scanner locked link mode.
Resetting the Standard Product Default Settings:
All Application Work Groups
The following bar code defaults all of the work groups to the factory settings.
The Menu Commands starting on page 10-6 list the standard product default
settings for each of the commands (indicated by an asterisk (*) on the program-
ming pages).
Standard Product Default Settings:
Current Application Group
Standard Product Default Settings:
All Application Groups