Filter
Top Products
4 - 10
Illumination Lights
If you want the illumination lights on while reading a barcode, scan the Lights
On barcode, below. However, if you want to turn just the lights off, scan the
Lights Off barcode.
Note: This setting does not affect the aimer light. The aiming light can be set
using Aimer Mode (page 4-11).
Aimer Delay
The aimer delay allows a delay time for the operator to aim the image scanner
before the picture is taken. Use these codes to set the time between when the
trigger is pulled and when the picture is taken. During the delay time, the aim-
ing light will appear, but the LEDs won’t turn on until the delay time is over.
User-Specified Aimer Delay
If you want to set your own length for the duration of the delay, scan the barcode
below, then set the time-out by scanning digits (0 - 4,000 ms) from the
Programming Chart inside the back cover of this manual, then scan Save.
Lights Off
* Lights On
400 milliseconds
* Off
(no delay)
200 milliseconds
Delay Duration