Filter
Top Products
14
Figure 7. USB, Interface
³999998
Recall Defaults
INSTALLATION
CABLE INSTALLATION (INTERFACE SPECIFIC)
USB
1. Connect the keyed VLink cable to
the 10-pin Multi-Interface jack. It
is the only circular keyed jack
located on the bottom of the 7820
(see figure 7).
2. Connect the other end of the USB
cable to the host.
Before continuing, verify the USB
cable is connected to the
appropriate interface jack on the
scanner. An incorrect cable
connection can cause
communication problems or
potential damage to the scanner.
3. Scan the Recall Defaults bar
code to configure the 7820 for
USB communication.
4. Turn on the host system.
5. Snap on the cable cover.
For additional communication
options for USB interfaces refer to the
MetroSelect Configuration Guide
(PN 00-02407).
See SELV Power caution statement located on page 11 of this manual.
Plugging the scanner into
the USB port of the PC
does not guarantee that
scanned information will
appear at the PC. A
software driver and correct
configuration setting may
also be required for proper
communication depending
on settings.