Filter
Top Products
WEB-700 WEB-700-O CP-700
11 95-7776—03
ABOUT EXPANSION OPTIONS
The WEB/CP-700 provides for field-installable expansion using these types of options:
• Option card — Install on connectors inside the WEB/CP-700 base unit. See About Option Cards, page 11.
• Remote I/O modules — To wire to the WEB/CP-700’s right-side 6-pin connector. See About Remote I/O Modules, page 12.
• MiniPCI option card — (future use). See About MiniPCI Cards, page 12.
About Option Cards
The WEB-700/CP has two (2) available option slots to accept a custom option card, compatible with either of these types:
• Series 2 and 6 controller options cards: 30-pin, 2 row connector, or
• Future release Series 7 option cards: 40-pin, 3 row connector.
To accept either, both option slots on the WEB/CP-700 base board have a 40-pin connector. See Fig. 5, page 10. Installing an
option card is recommended before mounting the unit. See Installing an Option Card, page 12.
WARNING
Power to the WEB/CP-700 must be OFF when installing or removing option cards, or damage will occur! Also,
you must be very careful to plug an option card into its connector properly (pins aligned).
Option cards typically provide additional communications features, with the following available models (with others still in
development) listed in Table 2.
1
Unlike with a Series 2/6 controller with an NPB-MDM installed in slot 1, the onboard RS-232 COM1 port (DB9) remains opera-
tional. Also, any NPB-MDM option is unaffected by the “mode jumper” position for serial shell access (jumper in “serial shell”
position affects the operation of the onboard RS-232 COM1 port only).
Table 2. WEB/CP-700 Option Cards
Option Description Notes
NPB-2X-RS485 Dual, optically-isolated, RS-485 adapter with
two 3-position removable screw-terminal
connector plugs.
30-pin option card.
If installed in option slot 1, ports operate as COM5
and COM6.
NPB-LON FTT-10A LON (LonWorks) adapter
with a 2-position removable
screw-terminal connector plug.
30-pin (WEB-2/6) option card.
Port operates as LON1 if only one LON option, or
LON2 in slot 2 if two LON cards.
NPB-RS232 Single port RS-232 adapter, with a DB-9M
connector. Supports baud rates up to
115200.
30-pin (JACE-2/6) option card.
If installed in option slot 1, port operates as COM5.
NPB-GPRS-W-H GSM cellular modem card using GPRS
(General Packet Radio Service), with
onboard socket for SIM card, and a Wyless
SIM. Includes a stub SMA antenna.
30-pin (JACE-2/6) option card.
Card uses two WEB/CP-700 COM ports, e.g. COM5
and COM6 if option slot 1.
NPB-MDM
56Kbps Auto-dial/Auto-answer Modem
1
with
one RJ-11 connector for phone line.
30-pin (JACE-2/6) option card.
Does not have own UART (unlike most other serial
cards). Operates as COM3 if installed in option slot 1,
COM4 if in slot 2.