Filter
Top Products
27
TROUBLESHOOTING GUIDE
Symptoms Possible Cause(s) Solution
All Interfaces
The unit scans
a bar code, but
locks up after
the first scan
(the white LED
stays on).
The scanner is
configured to support
some form of host
handshaking but is not
receiving the signal.
If the scanner is setup to support
ACK/NAK, RTS/CTS,
XON/XOFF or D/E, verify that
the host cable and host are
supporting the handshaking
properly.
Scanner beeps
at some bar
codes and NOT
for others of the
same bar code
symbology.
The bar code may
have been printed
incorrectly.
Check if it is a check digit,
character or border problem.
The scanner is not
configured correctly
for the type of bar
code.
Check if check digits are set
properly.
The minimum symbol
length setting does not
work with the bar
code.
Check if the correct minimum
symbol length is set.
During power
up the unit
beeps three
times.
There is a non-volatile
RAM failure.
Contact a service representative.
During power
up the unit
razzes
continuously.
There has been a
diagnostic failure.
Contact a service representative.
During power
up the unit
razzes once
and the blue
LED flashes.
There is a VLD failure. Contact a service representative.
During power
up the unit
razzes twice
and both LEDs
flash.
There is a scanner
motor failure.
Contact a service representative.