Filter
Top Products
29
Regulatory Compliance
Safety
The IS4910 series area imaging engines are designed to meet the requirements of IEC Class 1 in accordance
with IEC 60825-1:1993+A1+A2. IEC Class 1 is defined as follows:
The specifications required for agency approval are not obtainable until the IS4910 / IS4911 area imaging
engine is used in its final configuration. Honeywell International Inc. is unable to fulfill these requirements
because the imaging engine will operate differently depending upon where the engine is used as a component.
If the product containing the IS4910 series engine is to be used in another country, the manufacturer who
incorporates the imaging engine into their product is responsible for fulfilling any regulatory
compliance requirements for that country. Refer to one of the following sections for further explanation.
Europe
The CE Mark is required on products that incorporate the IS4910 series engine if the products are to be
imported into European Economic Area (EEA) countries. Use of the CE Mark requires compliance with
directives and standards dependent upon the type of product. Information may be found at
http://europa.eu.int/comm/enterprise/newapproach/
.
LED Safety
IEC 60825-1:1993+A1+A2,
EN 60825-1:1994+A1+A2
“Safety of LED products”
Compliance with either of the standards listed above is required for the product to bear the CE mark.
Note: Non EEA countries may impose additional testing/certification requirements.
EMC
All combinations of IS4910 area imaging engines and associated electronics will require certification of
compliance with the European EMC Directive. EMC compliance of finished products in Europe can be
accomplished by the following method:
The manufacturer may certify to the EC’s Electromagnetic Compatibility Directive 89/336/EEC.
Compliance is required for the product to bear the CE Mark.
Note: Non EEA countries may impose additional testing/certification requirements.
The IS4910 series area imaging engine is designed to meet EN55022 Radiated Class B emission limits.
The engine was installed in a representative system and tested for compliance.
Electrical Safety
The IS4910 engines are built to conform to the European Low Voltage Directive 73/23/ EEC.