Filter
Top Products
Argecy Computer Corporation 248-324-1800
84
For entry and standard models, Parallel Strobe Adjust is set to Off (0), the
factory default.
This setting lets you increase the amount of time strobe is sampled to
determine that valid data is available on the parallel port.
• Press the operator panel button with a brief button press to scroll
through the settings (Off=0, On=+1, Auto=+2). Press the operator panel
button with a long button press to select and save the On or Auto
setting. As the setting is saved, all operator panel lights remain on for
approximately 2 seconds
• Press the operator panel button with a double button press to scroll to
the next menu item, USB Port Enabled.
Turn off the printer to exit the advanced troubleshooting mode.
USB Port Enabled is set to Auto, the factory default.
The Universal Serial Bus (USB) cable lets you connect a variety of
devices to your computer with a single cable.
• Press the operator panel button with a brief button press to scroll
through the settings (Off, On, Auto). Press the operator panel button
with a long button press to select and save the Off or On setting. As the
setting is saved, all operator panel lights remain on for approximately 2
seconds
• Press the operator panel button with a double button press to scroll to
the next menu item, USB NPA Mode.
Turn off the printer to exit the advanced troubleshooting mode.
This light sequence in
advanced troubleshooting
mode: Corresponds to this setting: