IBM 6341 Computer Hardware User Manual


 
DID YOU RECEIVE THE CORRECT RESPONSE?
If NO, continue to 002.
If YES, proceed to 003.
002
If the Power Management feature is enabled, do the following:
1. Start the Configuration/Setup Utility program (see Setup Utility program on
page 10)
2. Select Power Management from the Configuration/Setup Utility program
menu.
3. Select APM.
4. Be sure APM BIOS Mode is set to Disabled. If it is not, press Left Arrow (})or
Right Arrow (Æ) to change the setting.
5. Select Automatic Hardware Power Management.
6. Set Automatic Hardware Power Management to Disabled.
7. If the problem persists, continue to 003.
003
Run the Diagnostic programs. If necessary, refer to Diagnostics on page 12.
v If you receive an error, replace the part that the diagnostic program calls out or
go to Symptom-to-FRU Index on page 69.
v If the test stops and you cannot continue, replace the last device tested.
2 Hardware Maintenance Manual