Filter
Top Products
Installing a Network Interface Card
Important
Follow the instructions for handling static-sensitive devices described on page 97.
Use the following procedure to install a Network Interface card:
1. Unpack the network interface card, and set aside the software and documentation
that arrived with the card.
2. If you are installing a token ring card, you must complete the following procedure to
set the line speed for the card. If you are not installing a token ring card, skip this
step and go to Step 3.
a. Lay the token ring card in front of you with the faceplate towards you.
b. On the right, rear side are six pins and two small jumpers.
If you are installing the card for a 4Mbps network, place a jumper over the
pins labeled 4.
If you are installing the card for a 16Mbps network, place a jumper over
the pins labeled 16.
3. Switch the printer power off.
Attention: Do not switch the power off if the printer is printing a page. This action
jams the printer.
Chapter 7. Installing Printer Options 111