Filter
Top Products
Installing the Data Collector 25
:
Note: Enter the number for the backup product Data Collector you are installing.
9. The installer will prompt for the Data Collector Name. This is the ID that will be used on
the Portal side to authenticate the Data Collector. This value should be the same value you
configured on the Portal for the field “ID” during the Pre-Installation step.
Enter Data Collector Name
(Required Field)
Data Collector Name (DEFAULT: ):
10. The installer will prompt for the Data Collector Password. This is the password that will
be used on the Portal side to authenticate the Data Collector. This value should be the same
value you configured on the Portal for the field “passcode” during the Pre-Installation step.
Configuration Settings - 2
--------------------------
Enter Data Collector Password:
(Please enter the Password, which will be used to authenticate the Data
Collector with the Data Receiver)
(Required)
Data Collector Password: password1
11. The installer will prompt for the Data Receiver URL. This is the URL the Data Collector
uses to communicate to the Portal server. This is the URL the Data Collector uses to
communicate to the Portal server. The format of this URL should be:
http://aptareagent.yourdomain.com
It is similar to the URL you use to access the web-based Portal (http://
aptareportal.yourdomain.com).
IMPORTANT NOTE: Be sure to enter the URL with the prefix aptareagent
and NOT
aptareportal!
Configuration Settings - 3
--------------------------
Enter Data Receiver URL
(Required Field)
Data Receiver URL (DEFAULT: ): http://aptareagent.yourdomain.com
The installer will perform a post-install validation:
The installer will now configure and validate the installation.
This may take a few minutes.