Filter
Top Products
Modem Ring Detect: With this feature set to
Enabled, the computer will turn on automatically
when a ring is detected on the internal modem.
Wake Up on Alarm: You can specify a date and
time at which the computer will be turned on
automatically. This can be either a single event or a
daily event.
PCI Wake Up: PCI Wake Up uses PCI Power
Management Enabled (PME) to wake up the
computer when using token-ring, Ethernet LAN
adapters, modems, or other PCI cards capable of
waking up the computer. When you set PCI Wake
Up to Enabled, the computer will turn on when it
receives a specific signal from another computer on
when it receives a specific signal from another
computer on the local area network (LAN) or from a
modem signal.
Wake on LAN features can be used on the 6584 and
6594 computers. For further information, see “Wake
on LAN” on page 58.
Network settings
This section applies only to computers linked to a network.
The Configuration/Setup Utility program includes settings
that can be enabled and disabled to configure the network
interface in the computer. These settings are:
Flash over LAN (Update POST/BIOS over Network)
Wake on LAN
Flash over LAN (update POST/BIOS
over network)
Note: For local Flash (BIOS/VPD) update, see “Flash
(BIOS/VPD) update procedure” on page 54.
This setting is used to enable or disable the Flash over
LAN feature. When the feature is enabled, the system
programs, in the computer, can be updated remotely from
a network server. If the administrator password is set in
the computer, it does not have to be entered by the server.
To access the Flash over LAN setting:
1. Start the Configuration/Setup Utility program. See
“Setup Utility program” on page 41.
2. Select System Security.
3. Select POST/BIOS Update from the
Configuration/Setup Utility program menu.
4. To enable Flash over LAN, select Enabled.To
disable Flash over LAN, select Disabled.
5. Press Esc twice to return to the Configuration/Setup
Utility program menu.
PC 300 - 6584/6594
57