Filter
Top Products
13. Slide the heat sink 2 into position over the microprocessor. Lower the lever
1 to secure the heat sink.
Note: If you are replacing a defective system board, use the heat sink that
was removed earlier.
14. If you are replacing the system board, continue at step 12 on page 12. If you
are replacing only the microprocessor, continue at the next step.
15. Route the fan cable through the notch on the side of the air baffle. Then,
install the air baffle by aligning the tabs to the holes in the chassis.
16. Reconnect the fan cable to the system board.
17. Go to “Completing the parts replacement” on page 31.
18 Hardware Replacement Guide