Filter
Top Products
10
Adjusting the image
The image is already optimised for many display modes. However, the controls can be used to adjust the image to your
liking. IBM recommends that the factory preset image size position and shape is used when operating with a display mode
listed in Table 1.
12
3
4
5
6
7
8
9
Saving and cancelling changes
Your settings will be automatically saved after five
seconds.
Should you wish to cancel any geometry changes that
you have made, press the right hand side of Key 1 where
you see the following symbol within 5 seconds of
making the change.
Geometry reset
To reset the image size, position and shape to the factory
settings, press the left hand side of Key 1 where you see
the following symbol: .
There may not be any settings for the display mode you
are using and so the key may have no effect.
Image size, position and shape
adjustment
By using Keys 2-7 shown in the diagram above, you can
adjust the size, position and shape of the screen image.
The pictures show how the image is affected.
use.doc Page 10 Sunday, July 16, 1995 3:45 PM