Filter
Top Products
Detailed Installation 2-3
Copyright © 2006-2007 by LSI Corporation. All rights reserved.
– A CD containing MegaRAID drivers for supported
operating systems, an electronic version of this
User’s Guide
, and other related documentation
– A license agreement
– Warranty information
Step 2. Turn off the Power to the System
Review all safety information provided with the computer; then,
turn off the computer, unplug the power cords from the power
supplies, disconnect the computer from the network, and
remove the computer cover. See the documentation provided
with the computer for instructions. Before installing the
controller, make sure that the computer is disconnected from
the power and from any networks.
Step 3. Review the MegaRAID Controller Connectors
Refer to Chapter 3, “MegaRAID 8480 Storage Adapter
Characteristics” for a diagram of the MegaRAID 8480 RAID
controller with its connectors.
Step 4. Review the Controller Limitations
Review Section 1.2.1, “Controller Limitations” before you install
the controller in the system.
Step 5. Check the Memory Module
Ensure that the memory module is present and seated firmly in
the dual-inline memory module (DIMM) socket.
Step 6. Install the MegaRAID 8480 Storage Adapter
Select a PCI Express slot and align the controller’s PCI Express
bus connector to the slot. Press down gently but firmly to
ensure that the card is properly seated in the slot. Secure the
bracket to the computer chassis.
Figure 2.1 shows the installation of a RAID controller in a PCI
Express slot.
Attention
: To avoid damage to the computer, always remove the 8480
RAID Controller from the PCI Express slot before you
relocate or ship the computer.