Filter
Top Products
10
DEUTSCH
ENGLISHFRANÇAISESPAÑOLITALIANOJAPANESECOMPL & WARR
Auto Setup
Auto Setup
The Setup Utility
included on the setup
diskette is for displaying do
patterns. They do not replace
or modify the display dirver.
The Auto Setup instructions
require the monitor to be
warmed up for 15 minutes.
This is not required for normal
operation.
By pressing the
and keys
simultaneously allows direct
access to the auto set-up
controls.
When you first use your monitor you must perform Auto Setup. This
procedure sets up your monitor to process the video signals from your
computer without image discoloration or smearing. After you perform Auto
Setup, the settings are stored and used each time you turn on the monitor.
In order to optimise the displayed image a set-up utility is provided on the CD.
Operation of the utility is dependent on the operating system on your PC. For
correct operation locate the operating system on your PC from the table
below and follow the appropriate instructions. You may choose to run
AUTO
S
ETUP for each operating system that you use. This means that if you
sometimes use your monitor while running any version of Windows and
sometimes also use it from within DOS (not a DOS window), you must run
AUTO SETUP for both Windows and DOS. You may run versions of AUTO SETUP
in any order.
Before you begin
AUTO SETUP for your PC:
1. Make sure the PC’s video mode is set in the range of the supported
screen resolution shown in the table.
The AUTO SETUP process only
applies to the current screen
mode. When a new mode is
selected, repeat this section to
reset the monitor
You should perform AUTO SETUP for each screen mode you use.
Operating System Corresponding Auto Setup procedure
DOS
Auto Setup for DOS
Windows 3.1, Windows 95,
Windows 98, Windows
2000, Windows NT,
Windows Me or Windows
XP
Auto Setup for Windows 3.1, Windows 95,
Windows 98, Windows 2000, Windows
NT, Windows Me or Windows XP