Filter
Top Products
Set print station parameters
EIA-232 Syntax:
ESCc1n or X'1B6331;n'
where:
n Specifies the print station.
Bit # ↓ Station
LSB 0 Reserved
1 Customer Receipt Station
2 Document Station - Portrait Mode
3 Document Station - Landscape Mode
4 Reserved
5 Reserved
6 Reserved
7 Reserved
Purpose:
This command is used for setting the line spacing, margins, and tabs.
Remarks:
More than one station can be selected at the same time if the settings are
common to all of the selected stations.
Default:
n = 02 (customer receipt station)
Select 1/8-inch line spacing
EIA-232 Syntax:
ESC 1 or X'1B31'
Remarks:
In the thermal (receipt) station this would set line feeding to 25 steps/line.
In the impact (document - portrait) station this would be set to 6 steps/line.
Note: Spacing in the document-portrait is actually 8.5 lines per inch. Line
spacing dimension is approximate. For the impact printer in portrait
mode, the actual line spacing must be calculated using 51 steps per
inch.
In the impact (document - landscape) station this would be set to 16
steps/line.
This command should be sent after “Set print station parameters.”
Select 1/6-inch line spacing
EIA-232 Syntax:
ESC 2 or X'1B32'
Remarks:
In the thermal (receipt) station this would set line feeding to 34 steps/line.
In the impact (document - portrait) station this would be set to 8 steps/line.
Updated April 2, 2009
136 SureMark Printers User’s Guide