Filter
Top Products
12
2.2 Clear CMOS Setup
If the user wants to clear the CMOS Setup data (for example, the
user forgot the password and needed to clear the setup data then set
the password again), the user should close the JP2 (set the jumper
to 2-3) about 3 seconds, then open it again. For normal operation,
set the jumper to 1-2 or open JP2.
•
JP2: Clear CMOS Setup
JP2 DESCRIPTION
1-2 Keep CMOS Setup
(Normal Operation)
2-3
Clear CMOS Setup
2.3 Keyboard Power Selection
This board can support keyboard wakeup. If the user wants to
use this function, the keyboard has to be supplied with standby
5V by
setting the jumper to 2-3.
•
JP4: Keyboard Power Selection
JP4 DESCRIPTION
1-2 VCC
2-3
5VSB
2.4 Compact Flash Card Master/Slave Mode
Setting
•
JP3: Master/Slave Mode Setting
JP3 DESCRIPTION
OPEN SLAVE
SHORT
MASTER