Filter
Top Products
47
4.10 PnP/PCI Configuration Setup
This section describes configuring the PCI bus system. PCI stands for
Personal Computer Interconnect. It is a system which allows I/O devices
to operate at speeds nearing the speed the CPU itself uses when
communicating with its own special components. This section covers
some specific technical settings and it is strongly recommended that only
experienced users should make any changes to the default settings.
CMOS Setup Utility – Copyright © 1984-2000 Award Software
PnP/PCI Configurations
PNP OS Installed NO
Reset Configuration Data Disabled
Resources Controlled By Auto(ESCD)
x IRQ Resources Press Enter
x DMA Resources Press Enter
PCI/VGA Palette Snoop Disabled
Item Help
-------------------------
Menu Level ¾
Default is Disabled.
Select Enabled to reset
Extended System
Configuration
Data(ESCD) when the
user exits Setup if you
have installed a new add-
on and the system
reconfiguration has
caused such a serious
conflict that the OS
cannot boot
↑↓←→Move Enter: Select +/-
/
PU/PD: Value F10:Save ESC: Exit
F1:General Help
F5:Previous Values F6:Fail-safe defaults F7:Optimized
Defaults
Reset Configuration Data
In most cases, this field is set to “Disabled.” Select Enabled to reset
Extended System Configuration Data (ESCD) when you exit Setup if you
have installed a new add-on and the system reconfiguration has caused
such a serious conflict that the operating system can not boot.
The choice: Enabled, Disabled.