Filter
Top Products
43
IDE HDD Block Mode
Block mode is also called block transfer, multiple commands, or multiple
sector read/write. If the IDE hard drive supports block mode (most new
drives do), select Enabled for automatic detection of the optimal number
of block read/writes per sector the drive can support.
The choice: Enabled, Disabled
Onboard FDC Controller
Select Enabled if the system has a floppy disk controller (FDC) installed
on the system board. If the system has no floppy drive, select Disabled in
this field.
The choice: Enabled, Disabled
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and second
serial ports.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled,
Auto
UART Mode Select
Select a serial port 2 operation mode.
The choice: Normal, IrDA, ASKIR, SCR
Onboard Parallel Port
Select an address and corresponding interrupt for the parallel ports.
The choice: 378/IRQ7, 278/IRQ5, 3BC/IRQ7, Disabled,
Parallel Port Mode
Select a parallel operation mode.
The choice: SPP, EPP, ECP,ECP+EPP
Watchdog Timer Unit
Select the Watchdog Timer unit.
The choice: Second, Minute