Filter
Top Products
Remote Management
This option allows you to enable Remote management on the module.
The remote
management feature is designed to work only on the remote module of the
Local/Remote pair
. With Remote management enabled, you can easily perform the
following:
•
Test the line integrity of the remote copper port.
•
Use the Local unit to configure all SNMP-configurable features for both units.
•
Use the Local unit to download firmware for both units.
Refer to the
Module LED Functions
section for more information.
NOTE
When you enable the Remote management feature on the remote module, you
must disable SNMP-management on the chassis in which the remote unit is
installed (i.e. turn the iMediaCenter chassis SNMP switch off, or do not install an
SNMP Management module in either an iMediaChassis or iMcV series chassis.
Monitor/Boost Mode
This option allows you to boost the UTP receive signal (i.e internal linear gain boost).
This helps the UTP receiver to compensate for line loss.
NRZ (Non-Return-to-Zero)
This option allows you to enable or disable the NRZ mode.
NOTE
There are currently no applications that use any other settings than
AMI encoding
and
NRZ disabled
(Passive mode). Enabling NRZ can result in data corruption.
Enabling NRZ terminates the line coding on the copper line. This forces the module
to send raw data to the fiber line without line code information.
13