Filter
Top Products
MediaChassis
The MediaChassis provides a typical unmanaged chassis suitable for all remote
installation locations.
NOTE
Chassis may also be available in Industrial Ethernet (IE) configurations.
Each module requires one slot in the chassis. To install a module, remove the blank
brackets covering the slots where the module is to be installed (if present) by
removing the screws on the outside edges of the bracket. Slide the module into the
chassis, via the card guides, until the module is seated securely in the connector.
Secure the module to the chassis by tightening the captive screw. Save any “blanks”
removed during installation for future use should your configuration requirements
change.
Crossover/Straight-Through Connection
iMcV-T1/E1/J1 comes with an RJ48 UTP connector that features a push-button
switch, located next to the port, for selecting a crossover workstation or straight-
through connection. To select a cross-over connection, press the push-button IN. A
straight-through connection is selected when the push-button is OUT. When unsure
what type of connection you need, set the push button to the position that turns the
NO LNK LED off.
8