Filter
Top Products
15
Shutting down the projector
Screen Save Time
You can make the black screen appear after a preset number of minutes by
turning on the Screen Save Time feature in the Setup menu. See page 30.
Auto Off Time
The projector has an Auto Off Time feature that automatically turns the
projector off if no active sources are detected and no user interaction with
the projector is performed for 30 minutes. By default, this feature is off. You
can change the length of time, see page 30.
Turning off the projector
To turn the projector off, press the Power button on the remote or keypad.
The lamp turns off, a beep sounds and the LED blinks amber for 10 seconds
while the fans continue to run to cool the lamp. When the lamp has cooled,
the LED lights amber and the fans stop. Unplug the power cable to
completely power off the projector.
Troubleshooting your setup
The Status Indicator Panel on top of the projector indicates the state of the
projector and is helpful when troubleshooting
.
Table 1: Status indicator light behavior and meaning
Icon Meaning
Power, solid amber
Power, blinking green
Power, solid green
Power, blinking amber
The projector is plugged in.
The power button has been pressed and the software is
initi
alizing.
The projector is on and initialized.
The power button has been pressed to turn the projector
o
ff and the fans are running to cool the projector.
Temperature
The projector is too hot. Make sure the vents aren’t blocked
(see page 21). Turn the projector off and wait one minute,
then turn the projector on again.
Contact Technical Support
if the problem persists. Visit www.infocus.com/support to
contact service.
Lamp
Turn the projector off and wait one minute, then turn the
projector on again. If the lamp light turns on again, replace
the lamp and reset the lamp timer
(page 43).
Note: F
or dual-lamp projectors, one blink off every 2
seconds means the problem is with lamp #1; two blinks off
every 2 seconds means the problem is with lamp #2.
Wrench/Service
Turn the projector off and wait one minute, then turn the
projector on again. If the service lamp turns on again, service
is required. Visit www.infocus.com/support to contact
service.