Intel D810EMO Personal Computer User Manual


 
Technical Reference
49
2.9 Jumper Block
CAUTION
Do not move jumpers with the power on. Always turn off the power and unplug the power cord
from the computer before changing a jumper setting. Otherwise, damage to the board could occur.
Figure 7 shows the location of the BIOS Setup jumper block. This 3-pin jumper block determines
the BIOS Setup program’s mode. Table 34 describes the jumper settings for the three modes:
normal, configure, and recovery.
OM08928
31
J8F1
Figure 7. Location of the Jumper Block