Filter
Top Products
102
4
Supported Software
4.1 Desktop Management Interface (DMI)
The system board comes with a DMI built into the BIOS. DMI,
along with the appropriately networked software, is designed to
make inventory, maintenance and troubleshooting of computer sys-
tems easier. With DMI, a network administrator or MIS engineer
can remotely access some information about a particular compu-
ter system without physically going to it. Quite often a service call
may be unnecessary as the problem can be solved remotely.
The DMI utility in the BIOS automatically records various informa-
tion about your system configuration. Information about the type
and speed of CPU, type and amount of memory for each memory
slot, BIOS revision level, types of add-in PCI boards and compo-
nents, certain revision numbers of hardware installed, etc. are au-
tomatically detected and stored in the DMI pool, which is a part
of the system board's Plug and Play BIOS. Additional information,
such as ISA based peripherals, which may not be automatically de-
tected, can be manually recorded in the DMI pool by using the Add
DMI menu. The DMI pool data is then verified or updated when-
ever the system hardware or setup is altered.
4.1.1 Running the DMI Utility
To run the DMI utility, type: DMICFG.EXE. Please contact technical
support or your sales representative for the utility.
The DMI utility must run in real mode with at least 180K of base
memory. Memory managers like HIMEM.SYS (required by Windows)
must not be installed. You may do this by using one of the 3 methods
listed below.
1. Boot up from a system diskette without the AUTOEXEC.BAT and
CONFIG.SYS files,
2. “REM” HIMEM.SYS in the CONFIG.SYS, or
3. Press <F5> during bootup to bypass your AUTOEXEC.BAT and
CONFIG.SYS files.
Chapter 4 - Supported Software