Filter
Top Products
53
2
Hardware Installation
2
1
ON
2.6.9 Wake-On-LAN Connector
Your LAN card package should include a cable. Connect one end of
the cable to the wakeup header on the card and the other end to
location J10 on the system board. The network will detect Magic
Packet and assert a wake up signal to power-up the system. Refer
to the add-in card’s manual for details. Note: Your LAN card must
support the remote wake up function.
Important:
The 5VSB power source of your power supply must support
≥
720mA.
BIOS Setting
To use the Wake-On-LAN function, you must enable the “Wake
Up On LAN Connector” field in the Power Management Setup
of the BIOS.
1
3
WOL
Ground
+5VSB
!