Filter
Top Products
Installations
13
2.1.4 Setting Jumpers
There are jumpers on the Embedded Board of the IP-4MTS6B series.
You can set the jumpers to make the necessary operations.
Figure 7: Jumper Connector
For any three-pins jumpers (Figure 7), the jumper setting is 1-2 when
the jumper connects pins 1 and 2. The setting is 2-3 when pins 2 and 3 are
connected and so on. You see one of the lines surrounding a jumper, which
indicates pin NO.1.
To move a jumper from one position to another, use needle-nose pliers
or tweezers to pull the pin cap off the pins and move it to the desired
position.