Filter
Top Products
Award BIOS Setup
53
Use IR Pins:
This item allows you to select IR transmission routes, one is RxD2, TxD2
(COM Port) and the other is IR-Rx2Tx2.
The choice: IR-Rx2Tx2, RxD2 and TxD2.
Onboard Parallel Port:
This item allows you to determine access onboard parallel port controller
with which I/O address.
The choice: 3BC/IRQ7, 378/IRQ7, 278/IRQ5 and Disabled.
Parallel Port Mode:
Select an operating mode for the onboard parallel (printer) port. Select
Normal, Compatible, or SPP unless you are certain your hardware and
software both support one of the other available modes.
The choice: SPP, EPP, ECP and ECP+EPP, Normal.
EPP Mode Select:
This item allows you to determine the IR transfer mode of onboard I/O chip.
The choice: EPP1.7, EPP1.9.
ECP Mode Use DMA:
This item allows you to select a DMA channel for the parallel port for use
during ECP mode.
The choice: 3, 1.
PWRON After PWR-Fail: Options Off, Former-Sts.
This item allows you to select if you want to power on the system after power
failure.