Filter
Top Products
8
•
Installation
2.2 Unpacking
The PCI-7200 card contains sensitive electronic components that can be
easily damaged by static electricity.
The work area should have a grounded anti-static mat. The operator should be
wearing an anti-static wristband, grounded at the same point as the anti-static
mat.
Inspect the card module carton for obvious damage. Shipping and handling
may cause damage to the module. Be sure there is no shipping and handling
damage on the module before proceeding.
After opening the card module carton, extract the system module and place it
only on a grounded anti-static surface component side up.
Again inspect the module for damage. Press down on all the socketed IC's to
make sure that they are properly seated. Do this only with the module place on
a firm flat surface.
Note: DO NOT APPLY POWER TO THE CARD IF IT HAS BEEN DAMAGED.
You are now ready to install your PCI-7200.
2.3 Device Installation for Windows Systems
Once Windows 95/98/2000 has started, the Plug and Play function of
Windows system will find the new NuDAQ/NuIPC cards. If this is the first time
to installing NuDAQ/NuIPC cards in this system, Windows will require device
information source. Please refer to the “Software Installation Guide” for the
steps of installing the device.