Intel PCA-6175 Computer Hardware User Manual


 
60
PCA-6175 User's Manual
C.1 DiskOnChip
®
2000 Quick Installation
Guide
C.1.1 DiskOnChip 2000 installation instructions
1. Make sure the target platform is powered OFF.
2. Plug the DiskOnChip
®
2000 device into its socket. Verify the
direction is correct (pin 1 of the DiskOnChip
®
2000 is aligned with
pin 1 of the socket).
3. Power up the system.
4. During power up you may observe the messages displayed by the
DiskOnChip
®
2000 when its drivers are automatically loaded into
the system's memory.
5. At this stage the DiskOnChip
®
2000 can be accessed as any disk in
the system.
6. If the DiskOnChip
®
2000 is the only disk in the system, it will
appear as the first disk (drive C: in DOS).
7. If there are more disks besides the DiskOnChip 2000, the DiskOn-
Chip
®
2000 will appear by default as the last drive, unless it was
programmed as the first drive. (Please refer to the DiskOnChip
®
2000 utilities user manual.)
8. If you want the DiskOnChip
®
2000 to be bootable:
a . Copy the operating system files into the DiskOnChip
®
by using
the standard DOS command (for example: sys d:).
b . The DiskOnChip
®
should be the only disk in the systems or
would be configured as the first disk in the system (c:) using the
DUPDATE utility.
DUPDATE D /S: DOC104.EXB /FIRST (set as c:)
DUPDATE C /S: DOC104.EXB (set as d:)