Intel PCM-9387 Computer Hardware User Manual


 
39 Chapter 4
4.7.2 Reset Configuration Data
Default is Disable. Select Enable to reset Extended System Configura-
tion Data (ESCD) if you have installed a new add-on and system econfig-
uration has caused such a conflict that OS cannot boot.
4.7.3 Resources controlled by:
The commands here are “Auto” or “Manual.” Choosing “manual”
requires you to choose resources from each following sub-menu. “Auto”
automatically configures all of the boot and Plug and Play devices but
you must be using Windows 95 or above.
4.7.4 PCI/VGA Palette Snoop
This is left at “Disabled.”
4.8 Password Setting
To change the password:
1. Choose the “Set Password” option from the “Initial Setup Screen”
menu and press <Enter>.
The screen will display the following message:
Press <Enter>.
2. If the CMOS is good or if this option has been used to change the
default password, the user is asked for the password stored in the CMOS.
The screen will display the following message:
Enter the current password and press <Enter>.
3. After pressing <Enter> (ROM password) or the current password
(user-defined), you can change the password stored in the CMOS. The
password must be no longer than eight (8) characters.
Please Enter Your Password
Please Confirm Your Password