Filter
Top Products
Mainboard PM945GC(V2.0)
13
Printer Interface Header: PARALLEL (Optional)
This mainboard provides a PARALLEL header for you connecting an additional printer connector on your
case back panel. Attach the cable of printer connector (Optional) onto this header, and then you can use
the printer connector connecting with a printer.
Keyboard/Mouse & USB Power On function Header: JP1
PS/2 Keyboard and PS/2 Mouse attached to the back panel can awaken the system from sleep mode. In
order to enable this functionality, you must adjust the jumper caps on JP1 header as the table below.
JP1 Assignment
1
Pin 1-2 Closed
KB/MS & USB Power ON Disable (Default)
1
Pin 2-3 Closed
KB/MS & USB Power ON Enabled
Note: Close stands for putting a jumper cap onto two header pins.
USB Power On function Header: JP3
USB devices attached to the back panel USB ports can awaken the system from sleep mode. In order to
enable this functionality, you must adjust the jumper cap on JP3 header for +5V or +5VSB mode
depending on which USB port that the USB device is attached to.
JP3 Assignment Assignment
Pin 1-2 Closed
+5V
USB Power On Disable (Default)
Pin 2-3 Closed
+5VSB
USB Power On Enabled
Note: Close stands for putting a jumper cap onto two header pins.