Filter
Top Products
User Guide XB1 COM Express Module
©EKF -20- ekf.com
Installing and Replacing Components
Before You Begin
Warnings
The procedures in this chapter assume familiarity with the general terminology associated with
industrial electronics and with safety practices and regulatory compliance required for using and
modifying electronic equipment. Disconnect the system from its power source and from
any telecommunication links, networks or modems before performing any of the
procedures described in this chapter. Failure to disconnect power, or telecommunication
links before you open the system or perform any procedures can result in personal injury
or equipment damage. Some parts of the system can continue to operate even though
the power switch is in its off state.
Caution
Electrostatic discharge (ESD) can damage components. Perform the procedures described in this
chapter only at an ESD workstation. If such a station is not available, you can provide
some ESD protection by wearing an antistatic wrist strap and attaching it to a
metal part of the system chassis or board front panel. Store the board only in its
original ESD protected packaging. Retain the original packaging (antistatic bag and
antistatic box) in case of returning the board to EKF for rapair.