Filter
Top Products
User Guide XB1 COM Express Module
©EKF -21- ekf.com
Installing the Board
Warning
This procedure should be done only by qualified technical personnel. Disconnect the system from its
power source before doing the procedures described here. Failure to disconnect power, or
telecommunication links before you open the system or perform any procedures can result in personal
injury or equipment damage.
Typically you will perform the following steps:
C Switch off the system, remove the AC power cord
C Attach your antistatic wrist strap to a metallic part of the system
C Remove the board packaging, be sure to touch the board only at the heat spreader
C Insert module carefully into the complementary J-COM connectors on the carrier board
C Fix mounting screws
C Retain original packaging in case of return