Filter
Top Products
User Guide XB1 COM Express Module
©EKF -31- ekf.com
Connectors
Caution
Some of the internal connectors provide operating voltage (3.3V and 5V) to devices inside the system
chassis, such as internal peripherals. Not all of these connectors are overcurrent protected. Do not use
these internal connectors for powering devices external to the computer chassis. A fault in the load
presented by the external devices could cause damage to the board, the interconnecting cable and
the external devices themselves.
PLD Programming Header ISPCON
This pin header is the programming port for the on-board ispLSI2064 programmable glue logic chip.
The ISPCON is normally not stuffed.
ISPCON
1=3.3V 2=Serial Out 3=Serial In 4=ispGAL Enable
5=NC 6=Mode 7=GND 8=Clock
1
240.1.08.I
© EKF
ekf.com