Filter
Top Products
36 EasyCoder PL4 Printer User’s Guide
! U1 SETVAR “ip.gateway” “xxx.xxx.xxx.xxx”
! U1 SETVAR “ip.addr” “xxx.xxx.xxx.xxx”
where “xxx.xxx.xxx.xxx” will be replaced with valid values for
your network. If you are unsure what values to enter, please
contact your network administrator for assistance.
6 Turn the printer off and on.
7 Test the configuration. For help, see the next procedure.
To test that the printer is ready for LPD or TCP printing
1 Print a configuration label. For help, see “Verifying the
Printer Is Working” earlier in this guide.
2 Ping the IP address of the printer and verify
acknowledgement (from a DOS prompt on Windows
platforms).
3 Print a test label via Intermec PLUS. Test using TCP sockets
(port 6101) and LPD.
Setting Up WEP Encryption
W
E
P
E
n
c
r
y
p
t
i
o
n
W
E
P
E
n
c
r
y
p
t
i
o
n
PL4 printer
Access
point
Host
Laptop
PC
PL4U051.e
p
s
Before setting up the printer, you need to know the WEP key
that your wireless network is using. If 40-bit encryption is
enabled, the key is 10 hexadecimal (0 to 9, A to F) characters;
otherwise, if 128-bit encryption is enabled, the key is 26
hexadecimal characters.