IOGear GPSR01U Network Card User Manual


 
Select the Wireless tab. Enter the ESSID, Channel,
Rates that meet your network environment, then
press OK.
71
5.
Appendix
Appendix: Diagnostic Mode
If you’ve had problems with the setup of your
print server in your wireless network, please
refer to the following steps:
1. Change the print server to diagnostic mode by
switching the DIP switch to DIAG mode (the side
near to power connector.)
2. Change your wireless adapter to 802.11b Ad-hoc
mode, and the ESSID is WLAN-PS
3. Click Start > Programs > Network Print Server >
PSAdmin. Once PSAdmin starts, it will
automatically start searching for your print
server.
4. Once PSAdmin finds your print server, double
click on the Device name to open the properties
window.