Juniper Networks SRX 210 Network Card User Manual


 
Table 43: Component LEDs on the Services Gateway (continued)
Possible Causes and
Corrective ActionsMeaningStateLED
Normal condition. No
action is required.
The port is inactive.OffVoice Interface
LED
Normal condition. No
action is required.
The port is active and
functioning normally.
Green (Steady)
Normal condition. No
action is required.
The port is active and not
ready for data
communication.
Amber
Normal condition. No
action is required.
The port is active and data
communication is taking
place.
Green (Blinking)
Normal condition. No
action is required.
The port is initializing.
NOTE: The Voice Interface
port LED glows red (blinking)
while initializing. If there is
an error, the LED remains
red; otherwise, the LED
changes to green.
Red (blinking)
Contact the Juniper
Networks Technical
Assistance Center (JTAC).
See Juniper Networks
Technical Assistance
Center on page 128.
The Port has detected a
hardware initialization
failure.
Red (steady)
Related Topics Monitoring the SRX210 Services Gateway Chassis Using the CLI on page 117
Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions on
page 122
Monitoring the SRX210 Services Gateway Power System on page 125
Using the Reset Config Button on the SRX210 Services Gateway on page 126
Changing the Reset Config Button Behavior on the SRX210 Services Gateway on
page 127
Juniper Networks Technical Assistance Center on page 128
Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions
When the services gateway detects an alarm condition, the alarm LED on the front
panel turns red or amber as appropriate.
To view a more detailed description of the cause of the alarm , issue the show chassis
alarms CLI command.
122 Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions
SRX210 Services Gateway Hardware Guide