Juniper Networks SRX 210 Network Card User Manual


 
To accommodate the 150-watt power supply, use the 420028535 screw to
attach the adapter stopper bracket at the point on the chassis marked A.
Figure 16 on page 71 shows the adjustments to the power supply adapter tray
required for the 150-watt power supply.
Figure 16: Adjusting the Power Supply Adapter Tray to Accommodate the 150-Watt
Power Supply
1. Locations for the adapter stopper brackets in the power supply adapter tray
2. Fully configured power supply adapter tray
Related Topics Preparing the SRX210 Services Gateway for Rack-Mount, Desk-Mount, and
Wall-Mount Installation on page 65
Preparing the SRX210 Services Gateway for Rack-Mount Installation on page 66
Installing the SRX210 Services Gateway in a Rack
You can front-mount the SRX210 Services Gateway in a rack. Many types of racks
are acceptable, including four-post (telco) racks, enclosed cabinets, and open-frame
racks. For more information about the type of rack or cabinet the SRX210 Services
Gateway can be installed into, see SRX210 Services Gateway Rack Requirements
on page 52.
NOTE: The rack-mounting kit is not shipped with the device and must be ordered
separately.
Installing the SRX210 Services Gateway in a Rack 71
Chapter 12: Installing the SRX210 Services Gateway