Juniper Networks SRX 210 Network Card User Manual


 
Figure 20: SRX210 Services Gateway Rack Installation Hanging the Services
Gateway in a Rack
6. Have a second person install a mounting screw into each of the two aligned
holes. Use a number-3 Phillips screwdriver to tighten the screws.
7. Install the second screw in each mounting bracket.
8. Verify that the mounting screws on one side of the rack are aligned with the
mounting screws on the opposite side and that the device is level.
Related Topics SRX210 Services Gateway General Safety Guidelines and Warnings on page 133
Required Tools and Parts for Installing and Maintaining the SRX210 Services
Gateway on page 59
Preparing the SRX210 Services Gateway for Rack-Mount Installation on page 66
Adjusting the Power Supply Adapter Tray for the SRX210 Services Gateway for
Rack-Mount Installation on page 70
Installing the SRX210 Services Gateway on a Desk on page 75
Installing the SRX210 Services Gateway on a Wall on page 76
74 Installing the SRX210 Services Gateway in a Rack
SRX210 Services Gateway Hardware Guide