Filter
Top Products
7
Controls and Features
Front Side/ Top Surface/ Left Side
7 Air Inlets (on the front, right, and bottom side of
projector)
The air inlets absorb air to cool the internal components of
the projector. Do not block or allow warm air to blow into
them as it may cause damage.
• The air inlet filter on the right side cannot be removed.
Please clean the filter regularly with, for example, a
vacuum cleaner.
8 Remote Sensor (Front)
When operating with the remote control, aim it towards this
sensor. (☞ page 18)
•A remote sensor is also provided at the rear of the pro-
jector.
9 Focus Ring
Used to manually focus the projected image on the screen.
(☞ page 26)
p Zoom Ring
Used to manually zoom the projected image on the screen.
(☞ page 26)
1 Control Panel
For details, See ‘Control Panel on the Projector’.
(
☞
page 10, 11)
2 AC Power Input Terminal
This is where the supplied power cord is connected to.
(☞ page 24)
3 Carrying Handle
Use this handle when carrying the projector.
4 Foot Lever (for front adjustable foot)
Use when extending and retracting the front foot.
(☞ page 15)
5 Lens
The lens is a 1.3 x (zoom ratio) manual zoom lens.
Before projection, remove the lens cap. (☞ page 17, 24)
6 Lens Cap
It is recommended that the cap be fitted on the lens to pre-
vent it from becoming dirty when the projector is not in use.
(☞ page 24)
Using the Carrying Handle
8 Remote Sensor (Front)
4 Foot Lever
(for front adjustable foot)
7 Air Inlet
6 Lens Cap
2 AC Power Input
Ter minal
3 Carrying Handle
4 Foot Lever
(for front adjustable foot)
1 Control Panel
5 Lens
p Zoom Ring
9 Focus Ring