JVC DT-R24L41D Computer Monitor User Manual


 
9
6
For DT-R24L41D: AUDIO ASSIGN (MONITOR OUT) terminals (pin jack) / For DT-R17L4D: AUDIO (MONITOR OUT) terminals (pin jack)
Output terminals for the analog audio signal.
For DT-R24L41D: The terminals output the audio signal through AUDIO ASSIGN (IN 1 or IN 2) terminals when you select the video input
you have selected for “AUDIO1 ASSIGN.” or “AUDIO2 ASSIGN.” in “AUDIO SETTING” ( page 14).
For DT-R17L4D: The terminals emit the audio signals through the AUDIO (IN) terminal or EMBEDDED AUDIO signals through the E.
AUDIO HD/SD SDI (IN 1 or IN 2) input terminal.
The signal is output from this terminal only when the monitor is on or in “P.SAVE” (power save) mode ( “NO SYNC ACTION” on page 15).
The EMBEDDED AUDIO signal...
is decoded into an analog signal, then emitted.
is emitted only when “SDI 1” or “SDI 2” is selected, and when EMBEDDED AUDIO signals come in to the E. AUDIO HD/SD SDI (IN 1 or
IN 2) terminal.
has priority over the audio signal input to AUDIO ASSIGN (IN 1 or IN 2) terminals when “SDI-1” or “SDI-2” is selected for “AUDIO1
ASSIGN.” or “AUDIO2 ASSIGN.” and the EMBEDDED AUDIO signal is input to E.AUDIO HD/SD SDI (IN 1 or IN 2) terminal (DT-R24L41D
only).
7 E. AUDIO HD/SD SDI (IN 1, IN 2) terminals (BNC)
Input terminals for the HD/SD SDI signals.
The terminals accept also EMBEDDED AUDIO signals including up to 12 audio channels with a sampling frequency of 48 kHz.
8 E. AUDIO HD/SD SDI (SWITCHED OUT) terminal (BNC)
Output terminal for the HD/SD SDI signals.
The SDI signals of the current input (SDI 1 or SDI 2) are re-clocked, then emitted.
When an input other than SDI 1 and SDI 2 is selected, the SDI signal of the input selected last time is emitted from this terminal.
The signals are emitted from this terminal only when the monitor is on or in “P.SAVE” (power save) mode.
9 DVI-D (HDCP) terminal
Input terminal for the DVI-D signal compatible with HDCP.
When the picture is not displayed correctly, change the setting of “DVI INPUT SEL.” ( page 17).
Note for connections
Before making any connections, turn off all the equipment.
Use a cord whose plugs correctly match the terminals on this monitor and the equipment.
Plugs should be rmly inserted; poor connections could cause noise.
When unplugging a cord, be sure to grasp its plug and pull it out.
DO NOT connect the power cord until all connections are complete.
Refer also to the user manual of each piece of equipment.
Cover
2
AC IN
terminal
Case
1
CAUTION
Use only the provided screws.
Make sure the plug will not be pulled out after the cover is attached to the case.
The illustration above is of DT-R24L41D. When using DT-R17L4D, pay attention to the direction in which the power cord holder is
attached.
Attaching the power cord holder
The provided power cord holder prevents accidental disconnection of the AC power cord from the AC IN terminal.
The power cord holder consists of two parts, a case and a cover.
To detach the cover
3