Filter
Top Products
23
Details
Adjusts the dark shades of the image in gradation.
Adjustment of parts which are extremely bright and hard to see.
Adjusts the white balance for light red areas.
Adjusts the white balance for light blue areas.
Adjusts the white balance for dark red areas.
Adjusts the white balance for dark blue areas.
S CURVE
2.0
2.2
2.5
Increases the brightness of dark signal automatically.
ADVANCED SETTINGS
Helpful Hint ( /
NORMALIZE
Normalization)
Note:
In PICTURE, there is nor a noticeable change even when contrast is increased with a bright picture or reduced with a
dark picture.
PICTURE Adjustments
Item
PICTURE
BRIGHTNESS
COLOR
TINT
(NTSC only)
SHARPNESS
Effect Adjustments
Less More
Darker Brighter
Reddish Greenish
Adjusts the proper picture contrast.
Adjusts for easier viewing of dark pictures
such as night scenes and black hair.
Adjusts color saturation.
Adjust for natural flesh tones.
Adjusts picture sharpness.
Notes:
(1)
“COLOR” and “TINT”
settings cannot
be adjusted for “RGB” and “PC” input
signals.
(2) You can change the level of each
function (PICTURE, BRIGHTNESS,
COLOR, TINT, SHARPNESS) for each
PICTURE menu.
(3) The setting details for STANDARD,
DYNAMIC and CINEMA respectively
are memorized separately for each
input mode (INPUT1, INPUT2 ,
INPUT3 and PC IN).
(4) The “TINT” setting can be adjusted for
NTSC signal only during “VIDEO
(S VIDEO)” input signal.
Less More
Less More
N
Item
BLACK
EXTENSION
INPUT LEVEL
W / B HIGH R
W / B HIGH B
W / B LOW R
W / B LOW B
GAMMA
AGC
Effect
On the remote control unit, while the “ADVANCED SETTINGS” menu is displayed, if either the N button is pressed at any
time or the
(ACTION button) is pressed during “NORMALIZE”, then all adjustment values are returned to the factory
settings.
Less More
Less More
Less More
Less More
Down Up
Less More
Less More
OFF ON
(This cannot be adjusted when the input signal is RGB or PC.)
Notes:
(1) Carry out “W / B” adjustment as follows.
A Adjust the white balance of the bright sections using the “W / B HIGH R” and “W / B HIGH B” settings.
B Adjust the white balance of the dark sections using the “W / B LOW R” and “W / B LOW B” settings.
C Repeat steps A and B to adjust.
Steps A and B affect each other’s settings, so repeat each step in turn to make the adjustment.
(2) The adjustment values are memorized separately for each input mode (INPUT1, INPUT2 , INPUT3 and PC IN).
(3) The adjustment range values should be used as an adjustment reference.