JVC GM-V42PCEB Computer Monitor User Manual


 
7
ENGLISH
9 VIDEO A terminals (page 12)
AUDIO (L/MONO, R) input terminals (pin jack)
Connect these terminals to the audio input terminals of a
VCR, etc.
VIDEO IN terminal (BNC)
Connect this terminal to the video output terminal of a
VCR, etc.
VIDEO OUT terminal (BNC)
Connect this terminal to the video input terminal of
another Monitor.
Note:
• Since the video output terminals on this Monitor are
loop-through terminals, the devices connected to this
video output terminal should be correctly terminated.
Otherwise, pictures become abnormally bright or the
Monitor screen gets affected abnormally.
p VIDEO B terminals (page 12)
AUDIO (L/MONO, R) input terminals (pin jack)
Connect these terminals to the audio output terminals of
a VCR, etc.
Y/C (S video) IN terminal (mini DIN 4pin)
Connect this terminal to the S-video output terminal of a
VCR, etc.
VIDEO IN terminal (pin jack)
Connect this terminal to the video output terminal of a
VCR, etc.
Note:
• When both the video and S-video terminals are
connected, the S-video terminal will have priority.
q COMPONENT/RGB B input terminals (page 12)
AUDIO (L/MONO, R) input terminals (pin jack)
Connect these terminals to the audio output terminals of
the other equipment.
G, B, R, HD/Cs, VD (VIDEO) input terminals (BNC)
Connect these terminals to the following output
terminals of a personal computer or other equipment:
– Analog RGB signal output terminals
– Horizontal sync (HD) signal or composite (Cs) signal
output terminal
– Vertical sync (VD) signal output terminal
Notes:
• External sync signals are automatically detected when
they come in.
• When both horizontal (HD)/vertical (VD) sync and
composite (Cs) sync are connected, HD/VD sync signals
will be used.
Y, Pb, Pr (VIDEO) input terminals (BNC)
Connect these terminals to the component signal output
terminals of NTSC or high-vision equipment.
Note:
• When these terminals are used as the component
terminals (Y, Pb, Pr)—see “Setting the COMPONENT/
RGB B Input” on page 22, external sync signals (HD/Cs,
VD) cannot be used.
9 p q
VIDEO A
VIDEO
IN OUT
AUDIO
L/MONO
R
VIDEO B
VIDEO
IN Y/C IN
COMPONENT/RGB B
VIDEO
Y/G Pb/B Pr/R HD/Cs VD
AUDIO
L/MONO
R
AUDIO
L/MONO
R
Note:
* GM-V42PCE, GM-V42PCEG and GM-V42PCEB
do not have the following input terminals—
VIDEO A, VIDEO B, and COMPONENT/RGB B.
To input video, S-video, and component signals,
you need to install video input unit (IF-C42P1G),
which is separately purchased.
04_13_GM_V42[E].p65 03.6.23, 4:42 PM7