Filter
Top Products
77
Previous
screen
• The power cord may not be connected.
• The main power supply may not be supplied to the wall
outlet.
• The Status Codes are indicated on the STATUS Code
Display.
• The lamp unit or lamp unit cover may not have been
correctly installed.
• The Air Filter Unit may not have been correctly in-
stalled.
• The lens cap may still be attached to the lens.
• The signal input source may not be connected prop-
erly.
• The input selection setting may not be correct.
• The Brightness adjustment may be lowest setting.
• The LCD Projector may be set to the Shutter mode.
• The connected signal source may be turned off.
• The lens focus may not have been set correctly, or the
Projector may not be at the correct distance from the
screen.
• The lens may be dirty.
• The LCD Projector may not be set up so that it is per-
pendicular to the screen.
• The VIDEO or R, G, B adjustments may not have been
set correctly.
• Colour or Tint adjustment may be incorrect.
• The video formats may not match.
• The signal cables may be connected incorrectly. For
instance, the PB, PR connectors may be reversed.
• Do you use a polarization screen? A polarization
screen cannot be used.
Power does
not turn on.
No picture
appears.
The picture
is fuzzy.
Colour is too
light or tint is
poor.
Before Requesting Service
If the LCD Projector unit fails, check the following before calling
your dealer for service.
Problem Possible Cause
Continued on the next page...