Filter
Top Products
NJ750 Training Guide
9
2. Advance the media though the printer about 1 foot, using the Feed Media Menu/Forward
button.
3. Put the printer media feed in “Sheet” mode (Set-up Menu/Paper Option Menu/Supply
Type/Sheet). Using the media “Forward” button, drive the media forward until it is pulled tight.
4. Change the media feed back to “Roll” or “Take-up” (Set-up Menu/Paper Option Menu/Supply
Type/
5. Roll or Take-up).
6. Advance the media forward three feet to check alignment with the white media guideline.
7. Start printing the image.
G. ACCEPTABLE IMAGE SKEW:
W
L
L
OUT PU T
ACTUAL
MEDI A PERIMETE
R
PERFECT REFERENCE
RECTANGLE
L
12
L
EXHIBIT
A
Assuming the media loading instructions as defined in the user manual
have been followed, Exhibit A describes the maximum permissible
image skew.
The maximum skew is:
0.30% of ∆L = (L
1
- L
2
) – except for NJ880 (no skew specification has been
designated)
Example:
If L
W
= 59.61 inches (1.51 m.), L = 48.00 inches (1.22 m.)
Then: L
1
should equal L
2
= 76.53 inches (1.94 m.)
The actual permissible skew (L
1
- L
2
) = (.003) (76.53) = .229”
(5.82 mm.)
NOTE: This is the only method used to determine skew.